Milling and drilling

Milling can be used for cutting and for v-grooving when doing miter-fold joints, but can also be used for pre-drilling holes for assembly and engraving on the surface. Most importantly when drilling in the board is to make sure that the tools and bits are sharp. Especially when drilling a countersunk hole, tool sharpness is crucial.

Engraving

Due to the high density and layered construction of Solid Textile Board, precise engraving and two-tone 3D designs are possible. Depending on the design of the engraving, different tools and settings can be used. Due to the slow cutting speed used for engraving, chips can easily build up. Therefore, it is recommended to use a cutting tool intended for Plexiglas, as these tools are specifically designed to remove chippings.
Download the full processing and design manual here